TY - JOUR

T1 - Development and Computer Simulation of the New Combined Process for Producing a Rebar Profile

AU - Lezhnev, Sergey

AU - Naizabekov, Abdrakhman

AU - Panin, Evgeniy

AU - Tolkushkin, Andrey

AU - Kuis, Dmitry

AU - Kasperovich, Andrey

AU - Yordanova, Rozina

N1 - This research was funded by the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan (Grant No. AP14869135).

PY - 2023

Y1 - 2023

N2 - The study presents results of computer simulation by finite elements method of a new metal forming process combining the deformation of a billet with round cross-section on a radial-shear rolling mill and subsequent billet twisting in a forming die with a specific design. To analyze the efficiency of metal processing, the main parameters of the stress-strain state are considered: effective strain, effective stress, average hydrostatic pressure, and Lode-Nadai coefficient. The maximum value of effective strain up to 13.5 is achieved when a screw profile on the billet in the die is forming, which indicates an intensive refinement of the initial structure of the billet. During combined process, the nature of the deformation changes in the transverse direction from the axis of rotation to the surface. The central area of the billet is under the action of tensile stresses. In the peripheral part, compressive stresses grow. In the surface area, Lode-Nadai coefficient is 0.1 approximately, which indicates the high level of shear strain. © 2023 Sergey Lezhnev et al.

AB - The study presents results of computer simulation by finite elements method of a new metal forming process combining the deformation of a billet with round cross-section on a radial-shear rolling mill and subsequent billet twisting in a forming die with a specific design. To analyze the efficiency of metal processing, the main parameters of the stress-strain state are considered: effective strain, effective stress, average hydrostatic pressure, and Lode-Nadai coefficient. The maximum value of effective strain up to 13.5 is achieved when a screw profile on the billet in the die is forming, which indicates an intensive refinement of the initial structure of the billet. During combined process, the nature of the deformation changes in the transverse direction from the axis of rotation to the surface. The central area of the billet is under the action of tensile stresses. In the peripheral part, compressive stresses grow. In the surface area, Lode-Nadai coefficient is 0.1 approximately, which indicates the high level of shear strain. © 2023 Sergey Lezhnev et al.

UR - http://www.scopus.com/inward/record.url?partnerID=8YFLogxK&scp=85150443117

UR - https://gateway.webofknowledge.com/gateway/Gateway.cgi?GWVersion=2&SrcAuth=tsmetrics&SrcApp=tsm_test&DestApp=WOS_CPL&DestLinkType=FullRecord&KeyUT=000950437800001

U2 - 10.1155/2023/7348592

DO - 10.1155/2023/7348592

M3 - Article

VL - 2023

SP - 1

EP - 10

JO - Modelling and Simulation in Engineering

JF - Modelling and Simulation in Engineering

SN - 1687-5591

ER -