Friction treatment (FT) with a sliding indenter forming nano- and submicrocrystalline austenite structures in the surface layer of austenitic steel 03Kh16N14M3T (the volume fraction of strain martensite does not exceed 1.5%) is studied. It is shown that the FT hardens the surface of the steel to 720 HV0.025 and raises the wear resistance under the conditions of sliding friction with a lubricant by a factor of 4 - 70. This is associated with restriction of processes of plastic displacement and seizure on the nanostructured surface, which is confirmed by the results of microindentation.
Translated title of the contributionИсследована фрикционная обработка (ФО) скользящим индентором, формирующая в поверхностном слое аустенитной стали 03Х16Н14М3Т нано- и субмикрокристаллические структуры аустенита (объемная доля мартенсита деформации не превышает 1,5 %). Показано, что ФО обеспечивает упрочнение поверхности стали до 720 HV0,025 и рост износостойкости в условиях трения скольжения со смазкой в 4 - 70 раз. Это связано с ограничением на наноструктурированной поверхности процессов пластического оттеснения и схватывания, что обосновано результатами микроиндентирования.
Original languageRussian
Pages (from-to)21-24
Number of pages4
JournalМеталловедение и термическая обработка металлов
Issue number12 (774)
Publication statusPublished - 2019

    Level of Research Output

  • VAK List

    GRNTI

  • 53.00.00 METALLURGY

ID: 12032177